Serious question, is a $340 pin insertion tool worth it or did I just buy a fancy paperweight?
Dropped $340 on a Daniels-style pin insertion kit last spring because the rep swore it would cut my connector rework time in half. Instead it mangled two D38999 contacts on the first job in Wichita, and I spent 5 hours redoing pins I could have done by hand in 90 minutes. Now I'm torn, half of me says the tool is fine and I just need more practice, the other half says send it back and stick with my $40 crimper and a light touch. Curious where the old hands land on this, is it operator error or are these kits overhyped?
Gotta disagree on sending it back. A Daniels kit is not overhyped, it just punishes sloppy technique way harder than a hand crimper does. Two mangled contacts on the first job sounds like the classic stuff, wrong positioner tip for the contact size, pin not seated all the way in the tool, or twisting instead of a straight push. The fact that the rep sold it as a time saver did you no favors, because the tool only saves time once your hands know the feel. Keep it, grab some scrap connectors, and run 20 or 30 pins through it before you judge the thing.