Unpopular opinion: a good avionics tech should be able to pull a whole harness without a schematic
I was doing a nose-to-tail rewire on a Cessna 172 at a shop in Bakersfield last summer and a ramp guy yanked the battery cable before I had the breaker pulled, so I lost the whole avionics stack mid-diagnosis. I had 40 minutes before the owner showed up and the schematic was a coffee stained mess from 1978, so I traced the pins by hand off the connector shells. Cost us a full day of downtime but I found two chafed wires behind the panel that the drawing never flagged. Now I always label every lead with numbered tape before I touch a plug, and it saved me 3 hours on the next one. If your first move is to grab the manual instead of your meter, you are going to eat that lost time. What do you guys do to keep track of a messy bundle when the print is bad?