I wrote off live tooling on our old lathe til a spun part in Reno cost us 6 hours
Ran a batch of 4140 shafts on the SL-20 last Tuesday and the drill walked .030 on the third part because I was feeding too hot off center. I clamped an indicator on the turret, dropped the feed to 3 IPM and bumped coolant, and every part after that held within .002. Any of you run peck cycles different on short parts?
So the drill walked cause you were feeding it like it owed you money, huh. Wild how a guy can babysit the indicator for two minutes and save a whole shift of scrap. Short parts always seem to want a lighter peck, they got no meat to hold things straight.